Thursday, January 10, 2019

Comic Book Rose Wedding Bouquet

On Tuesday, I shared how to make paper roses, using measuring spoons to form each petal. Today, I am sharing how to turn those roses into a unique and beautiful bridal bouquet -- Dr. Who style!


To create the bouquet, I ordered a couple of Sonic Screwdrivers from Amazon, and bought a couple of Styrofoam spheres from a local craft store. I bought two sizes of each item, because I wasn't sure which would work best. After some experimentation, and consulting with the bride, I chose the larger Sonic Screwdriver and the six inch diameter Styrofoam sphere. The "screwdriver" would be the bouquet's handle, and the sphere would be the base of the bouquet.


The comic book page roses would be adhered to the base, using hot glue.


I started by flattening one side of the styrofoam base. This was done by carefully pressing one side of the sphere against a hard flat surface. Next, I took a steak knife and "drilled" out a hole for the top of the "screwdriver." Since the screwdriver actually opens up and lights up, I was careful to insert the handle so that the part that opened could open, and the part that lighted up could be seen from the top of the bouquet.


Next, the roses were attached to the styrofoam, starting at the bottom, and working up.


The bride wanted plain blue roses interspersed with the comic roses, so those were added, as well.


I was careful to use all predominately orange petals, or all blue petals, etc, when making each rose, and was mindful of how the colors were distributed throughout the bouquet.


After all the flowers were in place, the bottom of the bouquet needed to be addressed, as flattened Styrofoam is not terribly attractive.


I cut wide grosgrain and satin ribbon into six inch lengths and glued them into loops, as shown above.


These loops were then glued to the bottom of the bouquet, in alternating layers. To give the piece a nice finished look, I punched a large scalloped circle from a piece of the blue paper and cut a circle out of the center of the punched paper the same diameter as the collar of the screwdriver. A slit was cut into one side of the circle, so it could be slipped over the collar. This piece was then glued into place to cover the raw edges of the ribbon.


The bride loved her bouquet.


There were even enough extra petals to make the groom a matching boutonniere!


The wedding was beautiful, and the happy couple, a year and a half later, are the proud parents of a sweet baby boy!


This lovely couple may not live in the pages of a graphic novel, in their day to day life....


But they are definitely living their happily ever after.


If you enjoyed this post, you might also enjoy this post about how to make a flower garland.


If you enjoyed this tutorial, please subscribe to House Revivals in the sidebar, so you won't miss the fun projects we have scheduled. Find us on Facebook, too, so you can catch all the "in between" stuff, and see what I'm working on daily on Instagram. Feel free to link today's post to your favorite social media sites.

Thanks so much for stopping by!
Amanda